TeleAdapt TA-7630, Installation Manual

Page: 6 / 32

TA - 7630 and TA - 7730 Installation Manual
Last Revised: 9/30/11 10:47 AM
6
Definitions
Auto - sensing –
the automatic detection of a device plugged into an audio/video port
of the MediaHub. For example, MediaHub will auto - sense a Composite AV source
when a device is connected to the 3RCA ports and begin playing the Composite AV
Out content. When a laptop is plugged into the PC socket, MediaHub will detect a PC
Video source and begin to play the laptop video.
Auto - switching –
the automatic switching of the TV input away from regular
tuner mode (TV Mode) to MediaHub content (MediaHub Mode).
Control Cable –
MediaHub Active uses serial or game control protocol for implementing
the TV auito - switching feature. Most hospitality TVs support control protocols through the
following ports:
RS232 Serial Port (DB9)
Serial Control Jack (3.5mm)
Ex - Link Serial Control Jack (3.5mm)
RJP (RJ45 LG Remote Jack Pack)
GAME/DATA (RJ12 on TV or STB)
DIP Switches –
MediaHub Active has two DIP Switches located on the rear
of the unit. (See figure 1.) These switches must be configured accordingly to
allow appropriate communication between MediaHub and TV/STB. See the Installation
Instructions section.
RS232 –
MediaHub Active uses an RS232 serial control protocol for implementing the TV
auto - switching feature. Most hospitality TVs support RS232 protocol through their R S232
Serial Port (circular port with nine pins) or through their 3.5mm Serial Control port.
Figure 1: Dip switches located on the
rear of the MediaHub Active