TA
-
7630 and TA
-
7730 Installation Manual
Last Revised:
9/30/11 10:47 AM
29
Figure 1:
Prepare panels by removing the trims.
Figure 2: Flush
-
mount requires two hole cut
-
outs.
Figure 3: Secure panels with four CENTER screws
first, then snap on trim and secure outer screws.
Assemble Flush
-
Mount MediaHub Active with
Power
Hub
Extender
If you are assembling a MediaHub Active in a
Desktop Housing, refer to the Assemble
Desktop Housing section of this manual.
DO NOT follow instructions below.
1
|
Ensure DIP switches on back of MediaHub are set according to your MediaHub
installation instructions and cables are in place with mini co
nnectors positioned
toward the MediaHub panel.
2
|
Prepare MediaHub panel and PowerHub panel by removing
their trims. Use
a flat
piece of plastic, similar to a
business card
, between the end caps and the trim
base
, then removing trim bezel.
3
|
Attach
MediaHub cables and Cat5 Ethernet cable to the rear of MediaHub and
PowerHub panel.
4
|
Slide MediaHub panel and PowerHub panel into the casegood cut
-
outs. See
Flush
-
Cut Measurements section for cut
-
out dimensions.
5
|
Secure MediaHub and PowerHub panels
to the casegoods by first securing the
CENTER screws in place (two screws on the right side of the MediaHub panel as
well as the two screws on the left side of the PowerHub).
6 |
Snap the Extender Trim onto the MediaHub and PowerHub panels.
7
|
Secure
four outer screws.
8
|
Slide end caps onto MediaHub Extender
Summary of Contents for TA-7630
Page 1: ......
