Tele Radio PN-R15-1, Manual

Page: 69 / 92

REPLACE
You can replace a registered transmitter with another transmitter without having access to the receiver.
Use the new transmitter that you want to replace the old transmitter with.
1. Make sure that the stop button is pressed.
2. Press button 8. Keep pressed.
3. Twist and pull out the stop button.
4. Release button 8.
The top LED flashes (green).
5. WITHIN 1 MINUTE FROM PULLING OUT THE STOP BUTTON:
Enter the code: 1-2-3-4 (press the buttons 1, 2, 3, 4).
LEDs 1-4 light up (red). If the code is invalid, the transmitter turns off. When the code is accepted, the
top LED flashes (green). LEDs 1-4 flash (red).
6. WITHIN 1 MINUTE FROM ENTERING THE CODE:
Press button 3.
The top LED lights (green). LED 2 flashes (red).
7. Enter the Replace ID (a maximum of 11 digits) for the transmitter that you want to replace by pressing
the transmitter buttons.
LED 3 lights (red) when one or more digits have been entered. LEDs 3 + 4 light (red) when a maximum
number of digits (11) have been entered.
IMPORTANT! When entering the last digit in the
code, keep that button pressed until you have
pressed the stop button.
IMPORTANT! The Replace ID is placed in the
back of the transmitter. Remove the rubber cover.
This label is placed above the battery lid.
(000000)
Replace ID: 000000000
8. Press the stop button. Release the last digit button.
After approx. 10 seconds the transmitter turns off. NOTE! If replacing fails, press the stop button and
start over again.
- 19 -