Tele Radio PN-R15-1, Manual

Page: 66 / 92

START THE TRANSMITTER
NOTE! Only for continuous radio mode.
1. Make sure that the stop button is pressed.
2. Twist and pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor),
LEDs 3 + 4 flash (red).
3. Press the start buttons (buttons 7 + 8) at the same time for at least 1 second.
LEDs 3 + 4 light (red).
4. Release the start buttons.
LEDs 3 + 4 go out. The top LED flashes (green).
START THE TRANSMITTER IN MENU MODE
1. Make sure that the stop button is pressed.
2. Press button 8. Keep pressed.
3. Twist and pull out the stop button.
4. Release button 8.
Top LED flashes (green).
5. WITHIN 1 MINUTE FROM PULLING OUT THE STOP BUTTON:
Enter the code: 1-2-3-4 (press the buttons 1, 2, 3, 4).
The transmitter LEDs 1- 4 (red) light up. If the code is invalid, the transmitter turns off. If the code is
accepted, the top LED flashes (green), The transmitter LEDs 1-4 (red) starts to flash.
6. WITHIN 1 MINUTE FROM ENTERING THE CODE:
Enter a menu by pressing the buttons according to the table below:
1
3
5
6
4
2
7
1. Radio mode
2. Replace
3. Show channel
4. Auto shutdown
5. Load select mode
6. Logout
7. Shift button
8. Shift+3. Switch channel
9. Shift+5. Load at start-up
If no buttons are pressed within 1 minute, or if the stop button is pressed, the transmitter will turn off.
- 16 -