1
ES
FR
DE
EN
DK
NO
SE
NL
Programming tHe fUnCtion SeLeCtion on tHe tranSmitter:
1. Start the transmitter by pressing the start buttons for at least 1 second.
– The red LED 3 lights continuously.
2. Release left start button, but hold right start button.
NOTE! You have 0.3 seconds to perform the action in step 3.
3. Release right start button and then select button 1 for function selection. (If you do not press any of the func-
tion buttons the transmitter starts.)
– The yellow LED 2 lights continuously and the green LED 3 starts to flash.
4. Enter the safety code: 1, 2, 3, 4. You have 5 seconds per button, if the time elapses the transmitter switches
off.
– The green LED 3 flashes and the yellow LED 2 goes out if the safety code is correct.
5. Choose the respective function options (button 0, 1, 2 or 3). The yellow LED 1 lights each time an accepted
button is pressed.
– Once you have selected a function option the yellow LED (1) flashes 3 times and programming is complete.
NOTE! The function is deprogrammed using the 0 button.
6. Restart the transmitter by pressing the start buttons.
yELLOw LED/STaRT-up
If function selection 1 or 2 is programmed in 860 mode it is possible to choose which yellow LED/LED’s that
should be on when starting the transmitter.
Yellow LED start-up options, function selection 1:
• Option 0: No yellow LED’s.
• Option 1: Yellow LED 1 is on.
• Option 2: Yellow LED 2 is on.
• Option 3: Yellow LED 1+2 is on.
Yellow LED start-up options, function selection 2:
• Option 0: No yellow LED’s.
• Option 1: Yellow LED 1 is on.
• Option 2: Yellow LED 2 is on.
Programming yeLLoW LeD/Start-UP
1. Start the transmitter by pressing the start buttons for at least 1 second.
– The red LED 3 lights continuously.
2. Release left start button, but hold right start button.
NOTE! You have 0.3 seconds to perform the action in step 3.
3. Release right start button and then select button 1 for function selection. (If you do not press any of the
function buttons the transmitter starts.)
– The yellow LED 2 lights continuously and the green LED 3 starts to flash.
4. Enter the safety code: 7, 4, 8, 3. You have 5 seconds per button, if the time elapses the transmitter switches
off.
– The green LED 3 flashes and the yellow LED 2 goes out if the safety code is correct.
5. Choose the respective yellow LED start-up option (button 0-3).
– The yellow LED 1 lights each time an accepted button is pressed. Once you have selected a function option
the yellow LED (1) flashes 3 times and programming is complete.
6. Restart the transmitter.
