0
ES
FR
DE
EN
DK
NO
SE
NL
Do tHe foLLoWing to rePLaCe a tranSmitter:
1. Check the ID-code on the transmitter that should be erased from the receiver.
2. Start-up the transmitter that should be programmed into the receiver. You must be in the working range of
the receiver that should be erased and programmed.
3. Press the stop button on the transmitter.
– The red LED 3 lights continuously for 1 second, then (on the transmitter) the yellow LED 2 lights continuously
and the red LED 3 starts to flash.
4. Enter the PIN-code. You have 2 seconds per button. If the time elapses, the transmitter will switch off.
– If no PIN-code has been programmed you should enter 4 zeros (0000).
5. If the PIN-code is ok, the transmitters yellow LED 2 goes out.
If the wrong PIN-code is entered the transmitter will switch off.
6. Enter the ID-code for the transmitter that should be erased (max 5 numbers). You have 2 seconds per but-
ton.
Please note that no zeros should be entered if the ID-code is less then 5 numbers.
For example: ID-code 678
should be 6, 7, 8 and not 0, 0, 6, 7, 8.
7. When the ID-code is entered the transmitters red LED 3 lights continuously and the yellow LED 2 will
flash. The transmitter will now send a command (10s) to the receiver to erase the selected ID-code and
program the ID-code for the operating transmitter.
8. When the transmitter has switched off it can be started-up and used with the selected receiver.
Please note that the erased transmitter can no longer be used together with the receiver.
LOCK/uNLOCK a RECEiVER
When a transmitter that is programmed to a receiver starts, the receiver “locks” on to the transmitter’s
ID code. In this position the receiver will only accept this transmitter (even if more transmitters have been
programmed on the receiver). The green LEDs 4 and 8 lights on the receiver to confirm that only the selected
transmitter can be used.
When another transmitter is to be used the receiver must first be unlocked. Another programmed transmitter
can then be locked on to the receiver.
UnLoCking tHe reCeiVer
The transmitter to be logged must be started/logged on.
on the logged on transmitter (alternative 1):
1. Press the stop button on the transmitter.
– The red LED 3 lights continuously for 1 second, then (on the transmitter) the yellow LED 2 lights continuously
and the red LED 3 starts to flash.
2. Enter the PIN code. You have 2 seconds per button.
– If no PIN code has been programmed you should enter 4 zeros (0000) to unlock the receiver.
3. If the PIN code is approved, the transmitter sends a signal to unlock the receiver. The transmitter switches
itself off and is now logged out.
– The green LEDs 4 and 8 on the receiver go out and it is now possible for another programmed transmitter to
be logged on.
If the wrong PIN code is entered the transmitter will switch itself off without unlocking the receiver.
on the logged on transmitter (alternative ):
1. Press push button 9 (left start button) on the transmitter and then press stop button.
– The red LED 3 lights continuously for 1 second, then (on the transmitter) the yellow LED 1 flashes. The
transmitter then automatically sends a signal to unlock the receiver.. The transmitter switches itself off when
this operation is done and the transmitter is logged out. The green LEDs 4 and 8 on the receiver go out and it
is now possible for another programmed transmitter to be logged on. NOTE! this way of unlocking the
receiver requires that no dangerous function is placed on button 9 (left start button)
