0
EN
DE
FR
ES
NL
SE
NO
DK
UnLoCking tHe reCeiVer WitHoUt a tranSmitter
1. Turn switch 2 to the ON position.
2. Press down the reset button.
– Green (4 and 8), red (5 and 9) and yellow (6 and 10) LEDs light continuously.
3. Release the reset button.
– The green (4 and 8) and red (5 and 9) LEDS go out. Yellow LED (6 and 10) lights continuously.
4. Turn switch 2 to the OFF position.
5. Yellow (6 and 10) LEDs go out.
The receiver can now be logged on to another transmitter.
RaDiO mODuLE mODE
If the 69 channel radio module is mounted in the transmitter it is possible to program the module to operate
in 3 modes. This is very useful when the 69 channel transmitter is used with a receiver with the 16+16 radio
modul (old 860 version). If the 16+16 channel radio module is mounted in the transmitter it is not possible to
select these modes.
Mode
Channels
0
1-69
1
1-16
2
17-32
Programming raDio moDULe moDe
1. Start the transmitter by pressing the start buttons for at least 1 second.
– The red LED 3 lights continuously.
2. Release left start button, but hold right start button.
NOTE! You have 0.3 seconds to perform the action in step 3.
3. Release right start button and then select button 2 for programming radio module mode. (If you do not
press any of the function buttons the transmitter starts.)
– The yellow LED 2 lights continuously and the green LED 3 starts to flash.
4. Enter the safety code 5, 3, 4, 6. You have 5 seconds per button, if the time elapses the transmitter switches
off.
– The green LED 3 flashes and the yellow LED 2 goes out if the safety code is correct.
5. Enter a 0 for mode 0 (1-69), a 1 for mode 1 (1-16) or a 2 for mode 2 (17-32).
– When you have entered the transmitting mode the yellow LED 1 flashes 3 times and the transmitting mode is
programmed. The transmitter switches itself off.
6. Restart the transmitter.
