0
EN
DE
FR
ES
NL
SE
NO
DK
CO-pROgRammiNg ThE TRaNSmiTTER aND RECEiVER
The receiver can be programmed to accept up to three different transmitters, where each transmitter has its
own unique code. The LEDs 6 and 10 on the receiver indicate how many transmitters have been programmed
in the receiver.
Not flashing
= No transmitter has been programmed
1 flash
= 1 transmitter has been programmed
2 flashes
= 2 transmitters have been programmed
3 flashes
= 3 transmitters have been programmed
1. On the receiver: turn the function selector switch 2 to the ON position.
2. Press the reset button on the receiver.
– The green, red and yellow LEDs 4-6 and 8-10 lights.
3. Release the reset button.
– The green (4 and 8) and red (5 and 9) LEDs go out. The yellow LEDs 6 and 10 light continuously.
(If the yellow and red LEDs flash alternately then three transmitters have already been programmed on the
receiver, so all the transmitters must be erased and reprogrammed.)
4. Start the transmitter by pressing the start buttons simultaneously for at least 1 second.
– Release the buttons.
5. Press the start buttons simultaneously again until the yellow LEDs 6 and 10 on the receiver start to flash.
The receiver has found the transmitter.
6 On the receiver: turn the function selector switch 2 to the OFF position.
7 The transmitter has been programmed.
NOTE! Do not forget to complete the Settings form after programming!
ERaSiNg aLL ThE TRaNSmiTTERS iN ThE RECEiVER
on tHe reCeiVer
1. Turn the function selector switch 2 to the ON position.
2. Press the reset button.
– The green (4 and 8), red (5 and 9) and yellow (6 and 10) LEDs light continuously.
3. Release the reset button.
– The green (4 and 8) and red (5 and 9) LEDs go out. The yellow (6 and 10) LEDs light continuously.
(If the yellow and red LEDs flash alternately this means 3 transmitters have been programmed in the receiver.)
4. Turn switch 2 to the OFF position.
5. Turn switch 2 to the ON position within 2 seconds.
– The yellow (6 and 10) LEDs flash and the receiver has been erased.
6. Turn switch 2 to the OFF position.
REpLaCE a TRaNSmiTTER iN ThE RECEiVER
It is possible to erase a programmed transmitter and program a new transmitter into the receiver without
putting the receivers DIP-switch in program mode. It is very helpful if you would like to replace a transmitter
without going up to a high mounted receiver on a crane. This operation will be done from the transmitter that
should be programmed into the receiver.
