Telco Depot TD100 SERIES, User Manual

Page: 11 / 71

- 10 -
Extension Be connected to the phone eg: "888"
Name Extension name (English letter is supported only) eg: "Tom"
Password Support default or random password, combined by letter and
figure, eg: "12u3b6"
Caller ID Caller's ID eg: "801"
Outbound CID Overrides the caller id when dialing out with a trunk.
VM Password Voicemail Password for this user, eg: "1234".
E-mail The e-mail address for this user, eg. "Tom@gmail.com"
Analog Phone If this user is attached to an analog port on the system, please
choose the port number here.
Dial Plan Please choose the Dial Plan for this user
，
Dial Plan is defined
under the "Outbound Routes".
Voicemail This user will have a voicemail account after choosing this option.
Can reinvite Set up calls directly between caller and receiver, after being
connected by IP PBX system. This method is known to cause
problems with certain hardware, such as the common Cisco ATA
186.
SIP Check this option if the User or Phone is using SIP or is a SIP
device.
IAX2 Check this option if the User or Phone is using IAX2 or is an IAX2
device.
T.38 Fax Enables T.38 fax (UDPTL) pass through on SIP to SIP calls
Agent Check this option if this User or Phone is an Call Agent.
NAT Check this option if the User or Phone is located behind a NAT
(Network Address Translation) enabled gateway.
Pickup Group Select your pickup group.
Delete VMail Voicemail will not be checkable by phone if you choose this option.
Messages will be sent by email only.
Note: You must configure SMTP server for this functionality.
DTMF Mode The Dual-Tone Multi-Frequency mode to be used is specified here
and can be changed if necessary. The default is rfc2833.
Video Call Enable/Disable Video call for this extension
Permit IP IP address and network restriction.
eg: "192.168.1.77" or "192.168.10.0/255.255.255.0"
Auto Provision TD IP PBX can work with Grandstream and Yealink IP Phone on
this function. Pls select the phone manufacture and input MAC
address of the IP Phone. For more details, pls check in Part 3.10
Codecs Configure The allowed and disallowed codecs can be selected by clicking this
link. Default codecs are alaw, ulaw and G.729.