Telair ice S2800, Manual For Installation And User Manual

Page: 11 / 28

Rev.001 ICE S 2800
11
4.5 Diffuser installation and air
conditioner fixing
Connect the ribbon cable from the diffuser
display to the connector of the ribbon cable
from the air conditioner circuit board (Fig. 10).
Position the diffuser horizontally and place
the rectangular expanded rubber fitting (Fig.
14, ref. 1) over inlet port profile (Fig. 14, ref.
2). If the roof is more than 35 mm thick, a
second fitting will need to be overlapped on
the first one.
The rectangular fitting has an adhesive side
so it can adhere to the diffuser or to the one
below in the case of multiple fittings. The
purpose of the fitting is to form a sealed
channel to connect the diffuser inlet port to
the outlet port on the bottom of the air
conditioner.
Open the two doors on the diffuser that give
access to the fixing screws and air filters.
Using the four M6 screws (supplied), attach
the diffuser to the bottom of the air
conditioner, thus securing it to the roof of the
camper (Fig. 16).
It is important to attach the screws according
to
a tightening torque of 1.6 Nm, that is,
0.16 kgm . You are advised to use a torque
wrench.
Incorrect tightening can damage
the support base of the air conditioner,
compromise the seal and cause loud
noise inside the vehicle when the
conditioner is in operation.
Once attachment has been completed, re-
close the doors.