Telair ice S2800, Manual For Installation And User Manual

Page: 16 / 28

ICE S 2800 Rev.001
16
4) By using the +HOUR and
–
HOUR keys,
set the stop time
5) Press the TIMER key once again
6) After completing the setting operations,
press the SET key
To delete timer programming press the
CLEAR key
The start and stop times are
programmable in 10 minutes' steps.
Start and stop will occur with a 10
minutes' tolerance with respect to the
programmed time.
5.15 Operation without remote control
In the event of loss or failure of the remote
control, you can still use the air conditioner:
switch it on/off by touching the touch-key
(ON-OFF symbol in relief) near the display for
about 5 seconds.
The air conditioner will start in automatic
mode, automatic fan speed, temperature
setting 24 °C.
6 MAINTENANCE
6.1 Cleaning the filters
To ensure full efficiency of the air conditioner,
clean the diffuser filters by washing them with
a neutral detergent solution; allow them to dry
well before refitting them in their housing.
To remove the filters (Fig. 22, ref.1) open
each diffuser door, and then slide them in the
directions indicated by the arrows to release.
Once
maintenance work has been
completed, put the filters back in their seats
and re-fasten them by sliding in the opposite
direction.
6.2 Unsatisfactory performance
In
most cases, poor air conditioner
performance is caused by incorrect use
rather than actual malfunctions:
•
The unit is too small for the volume of air
you wish to condition.
•
The vehicle is poorly insulated.
•
The doors are opened too frequently.
•
There are too many people inside the
vehicle.
•
The power supply voltage is incorrect.