Tektronix TLA7AA Series, Service Manual

Page: 66 / 116

TLA7AXX/TLA7NAX Logic Analyzer Module Service Manual
6- 11
Removal and Installation Procedures
This section describes how to remove and install the major mechanical and
electrical modules. The procedures in this section assume that you already have
removed the module from the mainframe.
WARNING.
Before doing any procedures in this manual, read the General Safety
Summary
and
Service Safety Summary
found at the beginning of this manual.
To prevent possible injury to service personnel or damage to electrical compo-
nents, read
Preventing Electrostatic Discharge on page 6--1.
Tools Required
Table 6--3 lists the tools needed to replace the internal components of the logic
analyzer module.
Table 6- 3: Tools required for circuit board replacement
Name Description
Screwdriver with a T-9 and a T-10 Torx tip Standard tool
1/4-inch nut driver Standard tool
9/16-inch nut driver Standard tool
Needle-nose pliers Standard tool
Torque Requirements
Tighten all T-9 and T-10 screws to 4 in. lbs. Tighten standoff posts to 8 in. lbs.