Tektronix TLA 714, Service Manual

Page: 66 / 159

Removal and Installation Procedures
TLA 714 Color Portable Mainframe Service Manual
4–19
Bottom Cover
Removing the bottom cover should only be necessary when replacing a flip stand
or rear foot. You may also need to loosen the mounting screws on one side of the
bottom cover to remove or replace either side cover or to remove the power
supply.
You will need a screwdriver with a size T-15 Torx tip to perform this procedure.
Use the following procedure to remove the bottom cover:
1. Set the mainframe with the cord-wrap feet on the work surface and the
bottom facing you.
2. Remove the four screws that attach the bottom cover to the mainframe. (See
Figure 4–6 on page 4–11.)
3. Lift bottom cover off.
Reposition the bottom cover on the bottom surface of the portable mainframe.
Insert the four screws that attach the bottom cover to the mainframe. (See
Figure 4–6 on page 4–11.)
Removal
Installation