Tektronix TLA 704, Service Manual

Page: 81 / 144

Removal and Installation Procedures
6–26
TLA 704 Color Portable Mainframe Service Manual
Cord-Wrap Feet
You will need a screwdriver with a size T-15 Torx tip (Table 6–1, items 1 and 2,
page 6–6) to perform this procedure.
Use the following procedure to remove the cord-wrap feet:
1. Set the mainframe so the bottom is on the work surface and the rear panel
faces you.
2. Do the Rear Chassis Fan Tray removal procedure, page 6–21.
3. Orient the chassis fan tray so that the cord-wrap feet are on the bottom and
the fans are on the top.
4. Press outward to unlatch the two tabs that connect each cord-wrap foot to the
chassis fan tray. (See Figure 6–11 on page 6–26.)
5. Remove the cord-wrap feet.
Press tabs
outward
Cord-wrap feet
Fan tray
Figure 6–11: Cord-wrap feet removal
Use the following procedure to reinstall the cord-wrap feet:
1. Push the cord-wrap feet into the holes in the rear chassis fan tray to snap
them into position.
2. Do the Rear Chassis Fan Tray installation procedure, page 6–22.
Removal
Installation