Tektronix RTX100A, Service Manual

Page: 88 / 160

Removal and Installation Procedures
5-8
RTX100A ISDB-T RF Signal Generator Service Manual
Read these general instructions before removing a module.
First read over the Summary of Procedures that follows to understand how the
procedures are grouped. Then read
Equipment Required
for a list of the tools
needed to remove and install modules in the RTX100A.
If you are removing a module for service, begin by performing the procedure
Access Procedure (page 5-14). By following the instructions in that procedure,
you remove the module to be serviced while removing the minimum number of
additional modules.
The procedures are described in the order in which they appear in this section. In
addition, you can look up any procedure for removal and reinstallation of any
module in the Table of Contents of this manual.
H
The
Access Procedure
on page 5-14 first directs you to the procedure(s) (if
any) that are required to access the module to be serviced, then it directs you
to the procedure to remove that module.
Table 5-3: Summary of procedures
Procedure Module Page
Procedures for
External Modules
H
Cabinet
H
Right-side cover
H
Left-side cover
H
Front-panel unit
H
Front-panel assembly
5-15
Procedures for Board
Modules
H
A150 ISDB-T RF
output board
H
A12 Main board
H
CPU board
H
A20 PCI Backplane
board
H
Printer connector
5-21
Procedures for Internal
Module
H
DVD drive
H
Hard disk drive
H
Internal and external
fans
H
12 V main power supply
H
A40 AC Distributer
board
H
RFI filter
5-26
General Instructions
Summary of Procedures