Tektronix RTX100A, Service Manual

Page: 48 / 160

Performance Verification
3-2
RTX100A ISDB-T RF Signal Generator Service Manual
Table 3-1: Equipment required for performance verification (Cont.)
Item Recommended equipment Minimum requirements Qty.
IEEE1394b hard disk drive 1 Novac NV-HD352WB and
hard disk drive (Tektronix part number
119-7146-00)
Test streams CD-ROM 1 Tektronix part number 063-3907-XX
Procedures
The following conventions are used in the performance verification procedures:
H
Each test lists the characteristic that is being tested and the equipment
required to perform the test.
H
Each test contains complete setup instructions, which allows you to perform
each test individually or in order.
H
The equipment connection illustrations are specific to the recommended
equipment (equipment nomenclature is labeled). If you are using substitute
equipment, the location of your signal connections may vary from those in
the illustrations.
NOTE. Before you begin the performance verification procedures, be sure that the
RTX100A is operating in an environment that is within the operating limits
described in Table 1-4 on page 1-11.
In addition, the RTX100A and the test equipment must be warmed up for at least
20 minutes to ensure accurate test results.