Tektronix RTX100A, Service Manual

Page: 128 / 160

Using the Recovery Discs
5-48
RTX100A ISDB-T RF Signal Generator Service Manual
Reinstalling the RTX100A Application
Perform the following procedure to reinstall the RTX100A application software:
1. Insert the MTX100A & RTX100A Application Software Recovery Disc
into the DVD drive.
2.
Double--click the
E:
drive icon (substitute your DVD drive letter if it is
different than E).
3. Double--click the Application_Software folder.
4.
Double-click the
setup.exe
icon. This installs the RTX100A application
software.
Perform the following procedure to reinstall the parallel driver:
1.
Double-click the
Driver
folder in the
MTX100A & RTX100A Application
Software Recovery Disc .
2. Double-click the SSD5411-32bit.exe icon.
3. Click Next in the resulting window. The License Agreement window
appears.
4. Select I accept the terms in the license agreement , and then click Next .
The
Destination Folder
window appears.
5.
Click
Next
. The
Setup Type
window appears.
6.
Select
Complete
and click
Next
. The
Ready to Install Program
window
appears.
7.
Click
Install
to proceed with installation.
8. When the InstallShield Wizard Completed window appears, click Finish
to complete the installation.
Restoring the IEEE1394b Port Speed Setting
The IEEE1394 port speed of the RTX100A is set to S400/S800 at the factory.
However, when you reinstall the Windows XP operating system, this setting
returns to the default value (S400). After you reinstall the operating system,
perform the following procedure to restore the IEEE1394b port speed setting:
1. Select Start > Run to open the Run dialog box.
2.
Enter
regedit
in the Run dialog box, and then click
OK
. This opens Registry
Editor window.
Installing the Parallel
Driver (Option SC Only)