Tektronix RTX100A, Service Manual, Page: 109 / 160

Removal and Installation Procedures
RTX100A ISDB-T RF Signal Generator Service Manual
5-29
Doing the Performance Verification and Running Sysprep.
If you replace the hard
disk drive, you must perform the following steps:
H
Do the performance verification procedures (refer to
Performance Verifica-
tion on page 3-1).
H
Run the sysprep batch file:
1.
Select
File
>
Exit
to exit the RTX100A application. The Windows XP
desktop appears.
2. Select Start > Run to open the Run dialog box.
3.
Click the
Browse
button.
4. Select C:\Sysprep\sysprep.bat .
5.
Click the
OK
button.
1. Assemble equipment and locate modules to be removed:
a. You need a screwdriver with a T-10 Torx tip.
b. Locate the fans in the locator diagram Internal modules, Figure 5-4,
page 5-13.
2.
Orient the instrument:
Set the RTX100A so its bottom is down on the work
surface and its front is facing you.
3.
Remove the internal fan: See Figure 5-13 on page 5-30.
a. Disconnect the cable from J180 on the A20 PCI Backplane board.
b. Remove the two rivets securing the fan to the chassis.
c. Lift the fan up out of the chassis.
4. Reinstallation: Perform step 3 in reverse order to reinstall the internal fan.
5. Remove the external fan: See Figure 5-13 on page 5-30.
a. Set the RTX100A so its bottom is down on the work surface and its rear
is facing you.
b. Disconnect the cable from J190 on the A20 PCI Backplane board.
c. Use a screwdriver with a T-10 Torx tip to remove the four screws
securing the fan and fan cover to the chassis.
6.
Reinstallation:
Perform step 5 in reverse order to reinstall the external fan.
Internal and External Fans