Tektronix MTS400 Series, Quick Start User Manual

Page: 91 / 96

User Maintenance
Clean the face of the CD-ROM drive monthly with a cloth dampened with deionized water.
CAUTION. Do not allow moisture to enter the disc drive. When power is applied, the internal components might be damaged.
Cleaning the Keyboard
Clean the exterior surfaces of the keyboard and integrated tracking device with a dry, lint-free cloth or a soft-bristle brush.
A swab is useful for cleaning in narrow spaces around the controls and connectors. Do not use abrasive compounds on
any part of the instrument.
CAUTION. Avoid getting moisture inside the keyboard and integrated tracking device during external cleaning and use
only enough solution to dampen the cloth or swab. Use a 75% isopropyl alcohol solution as a cleanser and rinse with
deionized water.
In Case of Problems
This section addresses problems that you may encounter while using the test system. This section does not identify speci fi c
problems related to performance veri fi cation or adjustments. The diagnostic procedures for the MTS400 Series system
provided in this section can help you isolate problems. For a performance veri fi cation procedure, refer to the MTS400 Series
Speci fi cations and Performance Veri fi cation Technical Reference , supplied as a PDF fi le on the MTS400 Series Product
Documentation CD-ROM.
Power-on diagnostics run when you fi rst power on the instrument to start the test system application. These diagnostics
check the operating system and hardware for correct operation. If error messages occur during the power-on diagnostics,
there may be a system error that prevents the MTS400 Series system software from starting.
The following table lists some of the symptoms of hardware problems (related to the operating system and peripheral devices)
and possible solutions.
Symptom Possible causes and recommended actions
Instrument does not power on Verify that the power cord is connected to the instrument and to the power
source.
Check that the instrument receives power when you push the On/Standby
switch; check that fans start.
Check that power is available at the power source.
Contact your local Tektronix service center.
Instrument powers on but does not complete
the power-on sequence
Check for and remove any disk in the fl oppy disk drive; make sure
instrument boots from the hard disk drive.
Power-on diagnostics fail Contact your local Tektronix service center.
MTS400 Series Quick Start User Manual 69