where to save it, and select OK. The specified file or files are saved. The next time you push Save, the same type files are
saved.
•
Screen Captures capture the entire screen, including most displayed configuration menus and dialog boxes.
• Default Setup restores the oscilloscope settings (horizontal, vertical, scale, position, and so on) to the factory default settings.
• Autoset automatically displays a stable waveform.
7.
Ground and Probe Compensation connectors: The Ground and Probe Compensation connectors are located at the lower right side
of the instrument, near the front panel. The Ground connector (the small hole in the case) provides an electrically grounded (through
a resistor) connection point to attach an anti-static wrist strap, to reduce electrostatic damage (ESD) while you handle or probe the
DUT.
The Probe Compensation connections provide a ground connector (upper tab) and 1 kHz square wave source (lower tab) for
adjusting the high-frequency response of a passive probe (probe compensation). The oscilloscope uses this signal to automatically
compensate supported probes, including the ones that ship with the product.
8.
USB Host ports (USB 2.0): USB ports are located at the lower right corner of the front panel, and on the rear panel. Connect USB
flash drives to which you can save or recall data (such as instrument software updates, waveforms, settings, and screen captures),
or connect peripheral devices such as a mouse or keyboard.
9.
FlexChannel probe connectors: FlexChannel connectors support all and TekVPI measurement probes, BNC passive
probes, the TPL058 FlexChannel Logic Probe, and BNC cables. You connect most probes simply by pushing them into the connector
until the probe seats with a click.
Getting acquainted with your instrument
4 Series MSO MSO44, MSO46 Quick Start Manual
23
