Tektronix CSA7404B, User Manual

Page: 355 / 438

Appendix A: Specifications
CSA7000B Series & TDS7000B Series Instruments User Manual
A- 21
Table A- 7: Input/output port specifications (Cont.)
Characteristic Description
n
Probe Compensator Output Front-panel BNC connector, requires Probe Cal Deskew Fixture for probe
attachment
Note: During probe calibration only, a relay switches a DC calibration voltage
to this output in place of the 1 kHz square wave. This voltage varies from
--10 V to +10 V with a source impedance less than 1
Ω
and short circuit
current as high as 300 mA.
Output voltage Frequency
500 mV (from base to top)
±
20% into a 50
Ω
load (Vol = --500 mV, Voh = 0 V typical)
1 kHz
±
5%
1 V (from base to top)
±
20% into a 1
ΜΩ
load (Vol = --1.0 V, Voh = 0 V typical)
n
Analog Signal Output amplitude BNC connector, provides a buffered version of the signal that is attached to
the channel 3 input when channel 3 is the trigger source
20 mV/div
±
20% into a 1 M
Ω
load 20 mV/div
±
20% into a 1 M
Ω
load
10 mV/div
±
20% into a 50
Ω
load
Offset: between --100 mV and --170 mV into 50
Ω
Analog Signal Output bandwidth typical 1 8 GHz into a 50
Ω
load Analog Signal Output bandwidth, typical 1.8 GHz into a 50
Ω
load
n
Auxiliary Output levels BNC connector, provides a TTL-compatible pulse (polarity selectable) for
each A or B trigger (selectable)
V
out
high V
out
low (true)
≥
2.5 V into open circuit,
≥
1.0 V into 50
Ω
load
≤
0.7 V with
≤
4 ma sink,
≤
0.25 V into 50
Ω
load