Instrument front panel, interface, and rear panel
AFG1022 Quick Start User Manual
21
Channel Select
1.
Push the front-panel
Ch1/2
button to control
the screen display. You
can toggle between the
two channels.
Channel output On/Off
1.
To enable CH1 signal
output, push the
front-panel
On/Off
with
yellow color.
2.
To enable CH2 signal
output, push the
front-panel
On/Off
with
blue color.
An LED turns on when the
corresponding channel
button is in the On state.
You can configure the
signal with the outputs
off. This will allow you
to
minimize the chance of
sending a problematic
signal to a DUT.
Display Both Channels
1.
Push the front-panel
Both
button to display
the parameters of both
channels.
2.
Push the front-panel
Ch1/2
button to switch
the editable channel.
3.
Push the Waveform buttons
to select waveform of
current channel.
4.
Push the bezel button to
choose the corresponding
parameter. Push it again
to switch the current
parameter, such as
Frequency/Period.
Turn
the general purpose knob
to change the value of
cursor position. Push the
/ direction button
to
move the cursor. (The
numeric keypad can not
be used to input.)