Removal and installation
c.
Remove the screw on the bottom near the center of the front panel edge.
d.
Remove the front panel.
3.
To remove the cover:
a.
Remove all screws from the top and bottom side of the module that attach
the cover to the chassis.
b.
Slide the chassis out toward the rear of the cover.
4.
To remove the lock-down shaft and bracket:
a.
Remove the two screws that attach the bracket to its mount. Remove
the bracket.
b.
Lift out the lock-down shaft.
5.
To reassemble the module:
Perform the disassembly steps in reverse order to
reassemble the module, considering the following sub-steps as they apply:
a.
If installing a replacement front panel, perform the following steps before
installing the front panel:
Remove the backing from the front panel label.
Align the holes and attach the label to the new front panel.
b.
If installing a replacement cover, perform the following steps before
replacing the cover:
Remove the backing from the antistatic label.
Install the antistatic label to the replacement cover.
DSA8300 Digital Serial Analyzer and Modules Service Manual
59
