Gaining
Access
To
The
Power
Supply
To
calibrate the
MicroLab
|
power supply,
the
personality
card
guide
rails
and
high
voltage protective cover
must
be
removed.
1.
Loosen
the two
screws
at
the
top
of
the personality
card
guide
rails,
as
shown
in
Fig.
6-3.
Calibration—MicroLab
|
Instruction
2.
Remove
the screw
holding
the
bottom
of
each guide
rail
3.
Set
aside
the
guide
rails.
4.
Remove
the
two
screws
at
the
front
of
the
high
voltage
protective cover
and set the
cover
aside.
To
reassemble the
MicroLab
|,
repeat
all
the
previous
steps
in
the reverse
order.
Loosen These
Screws
Remove These
Screws
High
Voltage Cover
2827-23
Fig.
6-3.
Personality Card Guide
Rails
And
High
Voltage Protective Cover.
The
guide
rails
and
high voltage
protective
cover must be removed
to
expose the power
supply.
6-3
Summary of Contents for 067-0892-00
