MAINBOARD BIOS SETUP
MAINBOARD BIOS SETUP
P5T30-B4 User’s Manual
23
Quick Power on Self Test
-
Speeds up Power On Self Test (POST) after the computer is
powered on. When set to Enable, the BIOS will shorten or skip some checks during POST.
Hard Disk Boot From
-
This option lets you choose to boot from Primary IDE Master (Pri-
IDE-M), Primary IDE Slave (Pri-IDE-S), Secondary IDE Master (Sec-IDE-M), Secondary
IDE Slave (Sec-IDE-S) or SCSI hard disk. Same as IDE options, the
Boot Sequence
in the
next field is set to
C, A
when the
SCSI
is chosen.
Boot Sequence -
When your system is powered on, the BIOS performs a variety of
operations, then attempts to boot an Operating System from either a hard drive, floppy
drive, or CD-ROM. This setting determines the sequence that the BIOS will follow when
searching devices for a bootable disk. Most users find the
C, A
setting to be most
beneficial, since it takes the least amount of time to boot the system. If however, you want
the ability to boot from a Floppy or CD-ROM drive, you would need to choose either the
A,
C
or
CDROM, C, A
setting. For instance, if your boot sequence was set to
C, A
and for some
reason you wanted to boot to your Floppy A: Drive, it would not be possible, since the BIOS
would always boot from the C: drive first. In this case, this setting would need to be
changed to
A, C
so that the system would first check the floppy drive for a bootable disk.
This would slow bootup speed, however, since the floppy would be checked on every boot.
C, A
System will first search hard disk drive then floppy disk drive for boot sector.
A,C
System will first search for boot sector on floppy disk, then hard disk.
C only
System will first search for boot sector on hard disk only.
CDROM, C, A
System will first search the CDROM drive, then hard disk drive and then floppy
disk drive for boot sector.
C, CDROM, A
System will first search for boot sector on hard disk drive , then CDROM drive,
and then floppy disk drive.
Swap Floppy Drive -
The hardware connections determine which floppy is configured as
drive A: and drive B: “Swapping” the floppy drives can be useful if your system has two
floppy drives, and you want the ability to boot from both. For example: Since a PC cannot
boot from the B: Floppy, you would need to “Swap” floppy drives A: and B: in order to set
the second floppy drive to drive A:, thereby making it bootable.
Boot Up Floppy Seek
-
When enabled, BIOS will attempt to move the head of the floppy
disk drive forth and back once during POST to see if the drive is working properly.
Floppy Disk Access Control
-
When
R/W
, the floppy disk can be read and written. The
other option is
Read Only
.
Boot Up NumLock Status -
When
On
, the NumLock key will be automatically enabled
when the system boots.
Boot Up System Speed -
Sets the system speed to High or Low. Generally, low speed
would only be used for troubleshooting purposes.
Summary of Contents for P5T30-B4
Page 2: ......
