CONNECTIONS
CONNECTIONS
P5T30-B4 User’s Manual
15
Power Supply Connector
The two cables from the standard 5-volt power supply connect to
the power connector on the mainboard (refer to page 6). You
must align the connectors on the power cable at a slight angle to
correctly fit them onto the mainboards power connector. Then,
press down on the connectors to lock them in place. The (2)
connectors should be installed so that the BLACK wires meet in
the middle of the connector.
This mainboard also features a supplementary ATX Power
Connector. Please refer to Appendix A for details.
Serial and Parallel Ports
The cables from the supplied serial port connector bracket hook to the COM1 and COM2
connectors on the mainboard. Generally, the upper serial port on the bracket would be
configured as COM1 and the lower port as COM2. Make sure to orient Pin-1 marked on the
mainboard to the RED stripe on the ribbon cables.
IrDA-compliant infrared module connector
The IrDA connector bracket hooks directly to this connector on the
mainboard. This connector provides support for the optional wireless
transmitting and receiving infrared module. You must first configure
through “UART2 Mode” in
INTEGRATED PERIPHERALS SETUP
where UART2 is directed, COM2 or IrDA. (* Pin-6 is reserved for
consumer IR input - remote control *)
USB Connector
This 8-pin connector permits connection of two USB peripheral
devices directly to the system without an external hub.
Summary of Contents for P5T30-B4
Page 2: ......