SETTING THE JUMPERS
SETTING THE JUMPERS
P5T30-B4 User’s Manual
14
JBF0-2: CPU Clock Ratio Selection
- This jumper is explained in detail on page 10.
J14: IDE Activity LED
- Hook the IDE LED lead to this jumper, with the RED lead
corresponding to Pin-1.
J15: System Functions Jumper Block
Pins [3 & 5] Turbo LED switch
- The Turbo function is not supported by this
mainboard. Therefore, the Turbo LED will always remain
lit as long as the system power is on.
Pins [7 & 9] SMI suspend switch lead
- If your system
case has a suspend switch, hook the lead from the switch to
pins 7 & 9. A suspend switch is used to save electricity by
putting the system into a suspend mode when the computer
is not being used. This switch could also be used by the
Turbo switch on the front of the system, since this
mainboard does not support that function. For this switch to
be functional, it must first be enabled in the Power
Management Setup in the BIOS Setup utility.
Pins [17 & 19] Reset switch lead
- Connects to the Reset Switch lead from the system
case. The reset switch is used to “cold-boot” the system without actually turning off the
power, reducing wear and tear on the power supply.
Pins [2, 6, 8, 10] Keyboard lock switch lead
- Pins 2 & 6 connect to the Power LED
from the system case. Pins 8 & 10 connect to the case-mounted keylock switch.
Pins [14 & 20] Speaker connector
- Connects to the Speaker lead from the system case.
JP1 & JP2: CPU Voltage Selection Jumper
- This jumper is explained in detail on page
10.
J12: CPU cooling fan connector
- This jumper is explained in detail on page 9.
JFS0-2: CPU Clock Selection
- This jumper is explained in detail on page 10.
.
Summary of Contents for P5T30-B4
Page 2: ......
