VFLASH Software
13-11
13.5.2 Transfer Status of External FLASH Programming Screen
When using a serial link, a control screen displays the transfer operation status and shows
each step in progress:
TRANSFER STATUS OF EXTERNAL FLASH PROGRAMMING
Erasing of all Flash devices installed, please wait . . .
Erase completed
Creating a bootable flash disk
Transferring the BOOT sector, FAT and root DIR . . .
Completed
Copying selected files. . .
Transfer completed: XX. X%
Transferring: FILENAME
Elapsed time: Xmin XXsec
Transfer complete
1.
The devices are erased (this may take some time).
2.
The base system information is transferred, followed by the file data itself.
3.
The data progress is displayed by XX% up to 100%. The actual file being sent is also
shown (unless a complete diskette copy is performed). In addition, the elapsed time of
the transfer is displayed.
If an error occurs during transfer, the system beeps twice to warn the user.
To signal the end of a successful transfer, a single beep is heard.
NOTE
The transfer operation can be time consuming in Serial Mode due to the
serial transfer speed and protocol.
4.
When the transfer is 100% complete, the following message is displayed:
Do you want to Reset the receiving system?
This software command is made available to restart the receiving system by remote. In
order for a new Flash disk to be recognized by the BIOS and DOS, the system must be
rebooted.
Summary of Contents for TEK-CPCI-1000
