Tekno RC ET48.3, Building Instructions

Page: 6 / 28

TKR5075
TKR5016B
TKR5401
TKR5429
TKR1222
TKR1222
TKR1525
TKR1529
TKR1222
TKR5016B
TKR1525
M3x14mm Cap Head Screw
x4
TKRBB05134
Ball Bearing (5x13x4)
x2
TKR1529
M3x20mm Cap Head Screw
x2
TKR1222
13x16x0.1mm Diff Shim
x2
TKRBB05134
TKRBB05134
TKR5405
TKRBB05134
TKR1603
TKR1603
TKR1525 TKR1525
Grease
Front
Note: flat spot
Rear
Note: flat spot
TKR1525 x2
TKR1525
TKR1222
TKR1226
TKRBB05134
TKR1603
M5x4mm Set Screw
x1
TKR1226
5x7x0.2mm shim
x1
TKR1529
Bag D
Rear Gearbox
(overview)
6
Step
D-1
Note: TKR1222 - The gear mesh should be as close as possible without any binding. Test the fitment of the diff
with both TKR1222 shims on the gear-side of the diff. If the diff turns freely without binding, continue to next
step. If the diff binds and does not turn freely (it will make a grinding or crunching sound when spun), remove
one TKR1222 shim from the gear side and install it onto the other side of the diff. Reassemble and test the mesh
again. If it is still binding, remove the second TKR1222 shim from the gear side and install it onto the other side
of the diff. When you are satisfied that you have the best gear mesh possible continue to the next step.
Step
D-2
Step
D-3
Thread
Lock
Note: The front and rear of
the car use different inner
bulkheads. The front is angled
whereas the rear is offset
and only slightly angled.
TKR5405
TKR1226