Tekno Point PIC-12C6, Use And Installation Manual

Page: 49 / 92

INSTALLATION MANUAL PICCOLO
17
condensate
drain
8.4 ELECTRICAL CONNECTIONS
8.5 COVER TUBES
1. Open the panel, remove the screw on the cable cover.
2. Thread the power cable on the hole at the back Inner Unity,
and then pull it out from the front.
3. Remove the cable clip, connect the power cord to the terminal
respecting the color; tighten the screw and then secure the cable
with the clip.
4. Place the back cover of the cables and secure it by tightening
the screw.
1. Coat the connecting pipes, power cable and drain hose with
tape.
2. reserve a certain length of the exhaust pipe and power cable
for installation. After having them covered for a certain length
separating the discharge tube and the power cable (as shown
in the figure).
5. Close the panel.
- All connections between Indoor and Outdoor Unit should be
carried out by qualified personnel.
- If the power cord is not long enough, contact the vendor and
request a new one.
- For air conditioners with power via plug, the plug must be
attached after installation.
3. cover them in the same way.
4. The coolant lines (gas / liquid) should be held separately at
the end.
- The power cable and the control wire can not be crossed.
- The drain hose must be covered from the end.
screw
panel
wiring cover
power
supply
1.
connecting pipe
gas pipe
tube of liquid
cables inside
outside power
drainpipe
power cord
band
insulating
INSTALLATION
49