8
123-0719-018
Connecting to Power
Warning!
Improper power connection may result in a risk of electrical hazard
.
Make sure of the following before plugging the NOVA Viking drill press into the power source:
1. The main power switch is turned off
2. Power source is switched off
The power cord that is installed on the NOVA Viking drill press will have a three-prong plug which includes a
ground prong. The plug must be connected to a matching outlet that his properly installed and grounded in
accordance with local electrical codes.
For 115V outlet only:
A temporary adapter can be used to plug into a two-pole outlet if a three-prong outlet is unavailable in your
environment. The ground tab on the adapter must be connected to the screw on the outlet for proper
grounding. This adaptor should only be used until a qualified electrician can install a properly grounded outlet.
Note:
If an extension cable is required, make sure to check the following:
1. Extension cable gauge
2. Is the cable properly insulated?
If in any doubt, please contact your local electrician to inspect the cord according to the local electrical
standards before using it.
IMPORTANT:
A surge protection device must be used when using the drill press.
A surge protection device must be rated to at least 15A should be used in countries where 115V are used as a
standard. In countries where 240V is used, a surge protector must be rated to either 10A or 15A.
A surge protector with Joules rating of 3900J will be suitable for DVR motors.
Make sure the “O”
side of the rocker
switch is pressed in
Turn the power
outlet switch to
the “Off” position
