If a fan oven is being installed, please
remember that this hob has only been cer-
tified to work with TEKA brand ovens.
Leave a space in the front of the cabinet so
that the hot air can ventilate properly. The
opening should be at least 5 mm high. The
longitude should be the width of the cabinet.
An opening of 20 mm should be made in
the back part of the cabinet in order to
allow cold air to enter (see figure 1).
INSTALLING
THE
AIR
NOZZLE
(MODELS …604)
Place the nozzle over the air vent with the
air valve toward the front part of the hob
and use the screws provided to screw the
nozzle. By doing so, the air nozzle will stay
braced to the back of the hob.
Warnings:
When hobs are handled before
being installed, care should be taken in
case there is any protruding part or
sharp edge which could cause injury.
When installing units or applian-
ces above the hob, the hob should be
protected by a board so that the glass
cannot be damaged by accidental
blows or heavy weights.
The glues used in manufacturing
the kitchen unit and in the adhesive on
the decorative laminate of the worktop
surface should be made to tolerate tem-
peratures of up to 100ºC.
TEKA assumes no responsibility
for any malfunction or damage caused
by faulty installation.
PLEASE REMEMBER THAT THE GUA-
RANTEE DOES NOT COVER THE
GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
Fastening the hob
When the gap has been properly sized, the
sealing washer should be put on the lower
face of the glass.
Silicone should not be
applied between the glass and the unit
GB
12
fig. 3
fig. 2
Model ...604:
57
5 m
ax.
W
L
The dimensions L and W are shown in the table
"Dimensions and characteristics" of the Technical
Information section.
Fitting holes
W
L
