Tegam 2711A, Operation Manual

Page: 53 / 98

7 - 3
7
RS-232 Adapter Cables
The following wiring diagrams illustrate proper interconnections between the
serial port of an IBM (or compatible) PC and the model 2711A RS-232
connector. The proper cable to connect DB-9 connectors is included with this
instrument.
To set the RS-232 parameters
1. Press the SETUP button.
Chapter 7 Remote Interface Operation
To set the RS-232 parameters
You must select the proper RS-232 settings to communicate between the
waveform generator and a computer. The following procedure will let you
change the generator to required settings.
The generator is set to the following
factory defaults: Baud Rate = 19200, Bits = 8D1S, Parity = None, Handshake =
HW (hardware). The only programmable parameter is Baud Rate.
RS232 = 19200,N81
2. Press the right-arrow key to select the parameter field and then select
the baud rate by turning the knob.
RS232 = 19200,N81