Tegam 2711A, Operation Manual

Page: 15 / 98

1 - 7
1
To select a standard waveform.
Chapter 1 Quick Start
To select a standard waveform
At the initial power-on, the generator outputs a free-running sinewave at 1 kHz.
The following steps will show you how to select another standard waveform.
1. Press WVFM (waveform) button.
Then, select Standard by turning the knob. The default length is set to 1000
points. You may change the length by placing the cursor under the number. If
you change the length to 200 points, the output frequency will increase by 5
times.
2. Press the down-arrow key to waveform selection menu.
Turn the knob to select one of the 10 standard waveforms.
3. Press the down-arrow key to select parameter(s).
WAVEFORM:
Standard 1000Pts
↓
WVFM:STDW:
↑
Ramp
↓
STDW:RAMP
↑
Duty Cycle = 100.0%
↓
Note: the standard waveform data is recomputed after the parameters are
changed. It may take a fraction of a second to several seconds to compute and
draw the new waveshape. The time to draw the waveform depends on the sample
length and type of waveform selected.
4. Press the right-arrow key to set parameter.
STDW:RAMP
↑
Duty Cycle = 100.0%
↓