UNLOCKED
Bracket Pin
Cam Lock
Pivot Pin
Bracket
C
B
A
STEP 2
Assemble Roller Hinges to Table Bed
UNLOCK
LOCK
LOCKED
FIGURE 4
FIGURE 6
FIGURE 5
FIGURE 7
FIGURE 8
NEVER disassemble the Roller Hinge Pivot Pin.
ALWAYS insert the 3-Hole Roller Hinge (with the Pivot Pin on top
and facing out) in the same direction as the arrow label located
inside of the Cam Lock for proper assembly.
WARNING
!
NOTE:
Some models come with Traction Handles pre-assembled to
the Roller Hinges. However, the assembly instructions detailed below
still apply.
• For ease of assembly, rest the Table Bed against the Crossbar
(Figure 5) at the front of the A-Frame.
• On one side of the Table Bed, lift and hold the Cam Lock up all
the way to unlock (Figure 6).
• In your other hand, hold one Roller Hinge near the Pivot Pin.
With the Pivot Pin facing out (away from the Table Bed), slide the
bottom of the Roller Hinge between the Cam Lock and th
e Bracket in
the same direction as the arrow label located inside of the Cam Lock.
TIP:
Make sure that the Cam Lock is completely open when inserting
the Roller Hinge, otherwise assembly will be more difficult.
• Engage one of the holes in the Roller Hinge over the Bracket Pin.
Figure 8 shows the Roller Hinge installed correctly, with the
Bracket Pin engaged in Setting C.
NOTE:
Refer to the Owner’s Manual for an explanation of the hole
settings. If you are unsure, use Setting C to start.
• Push down on the Cam Lock (Figure 7) to lock it and secure the
Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the
same hole setting on both sides.
• Familiarize yourself with the 3-Hole Roller Hinge and Cam Lock
terms (Figure 4).
7
