• Your model’s Main Shaft may differ from what is shown in the
figures, however the assembly instructions remain the same.
• Facing the front of the A-Frame, hold the Main Shaft in your left hand
with the height markings facing up. Slide the end of the Main Shaft
into the Main Shaft Housing (Figure 13), located at the base of the
Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin
(Figure 14) to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner’s Manual for more
information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar bumper on the
A-Frame (Figure 15).
IMPORTANT:
The Crossbar prevents the Table Bed from rotating
forward when the user steps on the Ankle Comfort Dial. If the
Main Shaft does not rest on the Crossbar bumper as shown in
Figure 15, then the Table Bed has been assembled backwards
onto the A-Frame.
This
MUST BE CORRECTED
before use. See also Image B on Page
11
to ensure correct assembly.
• Test the inversion table by hand for smooth and steady rotation
(Figure 16) and ensure that all fasteners are secure.
STEP 4
Assemble Main Shaft to Table Bed
PROJECT: 900LX
APPROVED:
FINISH:
DRAWING: ROY 2017/4/20
HARDNESS/CLASS:
UNIT: mm
SCALE:1:12
MATERIAL: ASSM
SHEET 1 OF 1 REV.01
REV.
DESCRIPTION
REV.DATE
APP.DATE
APPROVED
900LX-說明書-20170420-12017/4/18 上午 09:23:12
DWG. NO.: 900LX
TITLE:900LX倒立台
料號:
A
細部放大圖 A
比例 1 : 6
C
A
B
D
E
6
5
4
2
9
8
7
C
A
B
D
E
F
G
H
1
2
3
4
5
6
7
8
9
F
G
H
UNLESS OTHERWISE SPECIFIED
TOLERANCE ARE :
0 ~20 0.1
21~50 0.15
51~ 4/1000
ANGLE 0.5
3
FIGURE 13
FIGURE 14
FIGURE 15
FIGURE 16
9
