• Face the front of the A-Frame where the Crossbar is located (Figure 9).
• Grasp both Roller Hinges, right above the Cam Lock, and lift the
Table Bed. Allow the top of the Table Bed to rotate toward the floor,
so that the back of the Table Bed is now facing you and the top of the
Table Bed is in front of the Crossbar (Figure 10).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one
side at a time (Figure 11). The Self-Locking Hooks will open to allow the
Pivot Pin into the Hinge Plate slot, then automatically snap closed
over the Pivot Pin.
TIP:
You may need to push outward on the Hinge Plate in order for
the second Pivot Pin to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot in the
Hinge Plates, and that the Self-Locking Hooks have closed over both
Pivot Pins (Figures 11a & 11b).
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
could result in serious injury or death!
WARNING
!
STEP 3
Assemble Table Bed to A-Frame
• Rotate the Table Bed into the use position (Figure 12). Ensure that
it rotates smoothly. See also Image A on Page 11 to ensure
correct assembly.
TOP VIEW
INSIDE VIEW
FRONT
REAR
FIGURE 11
FIGURE 12
FIGURE 11b
FIGURE 11a
FIGURE 9
FIGURE 10
8
