Teesa TSA1530, Owner'S Manual

Page: 9 / 32

Owner’s manual 9
EN
handle and knobs. Housing of the kettle may increase its temperature - risk of scalding!
• Warning: If the kettle is overfilled, boiling water may be ejected.
WARNINGS
• Use only cold water when filling the device.
• The water level must be between the MAX and MIN marks.
• Switch the kettle off before removing it from the base.
• Always ensure that the lid is tightly closed.
• The base and exterior of the kettle must not become wet.
• Kettle body used must match with the kettle base.
oPERATIoN
Before using the kettle for the first time, fill the kettle with cold water and boil it. After the kettle switches
off automatically, pour the water out, and repeat the process.
1. Fill the kettle with water. Do not overfill, make sure the water level is between MAX and MIN
markings. Close the top lid of the kettle (if the lid will not be closed, the kettle will not switch off
automatically after boiling is finished).
2. Place the kettle on the base.
3. Connect the kettle to 220-240 V, 50/60 Hz socket.
4. Press the key shortly to turn the device on. The operation indicator will turn red and in TSA1530
model illumination will be on. The display will show current temperature of water inside the kettle.
The water will be boiled. Once the water is boiled, the device will beep 3 times and automatically
enter standby mode (the operation indicator will go off). After 1 minute of inactivity, the device will
beep again and switch off (the display will be off).
5. To use maintaining constant temperature/heating to the desired temperature function, turn the
kettle on with the button and then press the button. Next, press the button
repeatedly to set desired heating temperature, the display will show the set temperature (50 / 60 /
70 / 80 / 90) and the keep warm indicator will be on. Once you stop adjusting the temperature, the
numbers will flash 3 times, and then stop flashing which means the function has been activated. The
kettle will heat water inside up to the set temperature, and automatically enter standby mode after
the temperature is reached. It will turn back on and heat up the water whenever the temperature
drops down by around 5°C. The function can be active for up to 8 hours.
6. Note: the kettle can be switched off manually at any time by pushing the power button. Do not
remove the kettle from the base without switching off first.
7. Do not open the lid when pouring out the water. If the kettle is overfilled, boiling water may be
ejected - RISK OF SCALDING!
MAINTENANCE AND CLEANING
Always remove the plug from the mains supply before cleaning the kettle.
Clean the unit’s exterior periodically with a soft, slightly damp cloth. Never use chemical agents to clean this
device. Do not use abrasive scouring pads or powers. Do not immerse the kettle in water or other liquids.
After some time, depending on the nature of your water supply, a boiled scale deposit is naturally formed
and can be found mostly adhered to the heating element, thus reducing the heating efficiency. The
amount of boiled scale deposited largely depends on the water hardness in your area and the frequency