AR1061 1-port Ethernet ADSL2+ Router User‘s Manual
Page 10 of 59
4 Software Configuration
User can change settings via PC’s WEB browser. The following sections describe the set
up procedures. After successful setting, when you power on the AR1061 Router, it will
boot up and connect to ADSL line automatically. The Router can provide a PVC
(Permanent Virtual Channel) for “Bridge test” by default. The default configurations for
the system are listed below.
•
LAN IP address: 192.168.1.1, NetMask: 255.255.255.0
•
UART setting : 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
•
VPI/VCI for ATM : 8/32 for PPPoE
8/36 for PPPoE with Imagnio service
•
ADSL Line mode : Auto-detect.
4.1 Set your PC’s Ethernet port
AR1061 is an ADSL Router which support DHCP and default enable. You also can set
your computer IP Address as
192.168.1.x
within the same subnet as AR1061 (default IP
address is
192.168.1.1
) and netmask (default netmask is
255.255.255.0
). It can be done
thru the following way.
1. Click start > Control Panel
2. In the Control Panel, double-click Network Connections
3. Right-click Local Area Connection the click Properties
4. Select Internet Protocol (TCP/IP) then click Properties
5. The TCP/IP Properties windows appear. You can select obtain an IP
address automatically and click OK to have the AR1061 assign your
computer an IP address. Or you can enter the IP within the same subnet as
AR1061.
6. If your Internet Service Provider (ISP) gave you Domain Name System
(DNS) settings, enter them in the Use the following DNS server addresses
fields. If you are not sure of your DNS setting, contact your ISP.
7. Click OK to finish the setting.
4.2 Access the Web Page of Router
Type the Ethernet IP address of the modem/router on the address bar of the
browser. Default IP address is
192.168.1.1.
The “Enter Network Password” dialog box appears. Type the user name and
password and then click OK.
Default admin user name/password is as follows:
Username:
1234
/ Password:
1234
Once you have connected to ADSL router. You will see the status page.
