Tecnoware UPS EVO DSP PLUS 1.0 MM, User Manual

Page: 10 / 42

ENGLISH
User’s manual 6 UPS EVO DSP PLUS
4.4 STAND-BY Mode
If the UPS is in Stand-by mode, it is “inactive”. In Stand-by mode the Inverter is off and there is not Output power
but the UPS is not completely off: indeed the UPS recharges the batteries regularly.
If the OFF button is pressed when the UPS is in Normal mode, the UPS switches in Stand-by mode.
If the UPS is in Stand-by mode and the AC Input line is removed from UPS, then the UPS switches completely off.
The Stand-by mode is identified by:

The Led panel LED4, LED 7 are on (see fig. 3).
5 EXTERNAL DESCRIPTION
5.1 Front Panel
The front panel informs the user about operating status, alarm conditions and measurements. It also provides
access to controls and configuration parameters.
Front panel shown below consists of two parts:
1. LED panel provides complete information about the UPS status and existing alarms, Load and Battery level.
2. 1 push buttons enables the user to turn ON/OFF the UPS.
Figure 2 – Front panel