ENGLISH
UPS EVO DSP PLUS
3
User’s manual
2
General Characteristics
EVO DSP PLUS has all the advanced features which guarantee maximum reliability and safety:
Double-Conversion ON-LINE Transformerless technology
Sinusoidal wave generated by an IGBT Inverter
Output Voltage regulation
2%
Protection from overload and short circuits
Automatic Bypass to protect from accidental overload or Inverter fault
Start-up even under Mains OFF conditions
Automatic protection when Battery is low
Automatic restart, following an automatic shut-down due to Low Battery, once AC utility power comes
back on
Automatic Input Frequency (50 or 60 Hz)
Led panel for visualization of the path of energy flow
Acoustic signals of various kinds indicating alarm situations
Available settings of all the UPS parameters by user through front panel pushbuttons.
High efficiency
Maximum reliability
Smart design and easy to use
3
Receipt and site selection
Carefully remove the UPS from its packaging, and carry out a meticulous inspection. We recommend keeping the
original packaging in a secure place, in case you need to send the UPS for maintenance purposes. In case of
transport damage, notify the carrier and dealer immediately.
We recommend paying attention to the below points in order to choose a correct placement for your UPS:
The UPS is designed to operate in a protected environment (e.g. offices). We therefore recommend
installing it in a place with very little or no humidity, dust or smoke.
When the UPS is brought from a cold place to a warmer place, humidity in the air may cause condensation
in the UPS. In this case, allow UPS to stand for two hours in the warmer place before beginning with the
installation.
In all circumstances, see the “Technical Characteristics” chapter for environmental specifications and
check that the selected area meets these criteria.
During normal operation the UPS discharges a minimal amount of heat. So it is necessary to leave at least
10 cm of unobstructed space all around the UPS in order to keep it properly ventilated.
Do not obstruct ventilation holes.
Do not insert objects or pour liquids in the ventilation holes.
Do not rest any object on top of the UPS.
Do not keep liquids, flammable gases or corrosive substances near the unit.
Install the UPS on a properly tiled floor. Avoid the installation on a floor that is not tiled flat.
Summary of Contents for UPS EVO DSP PLUS 1.0 MM
Page 1: ...UPS EVO DSP Plus 1 0 MM Uninterruptible Power Supply User s manual Manuale utente...
Page 2: ......
Page 41: ......