Tecnospiro Roscamat TS-VIII, Instruction Manual

Page: 5 / 24

TS VIII PNEUMATIC MOTOR 5
1.2 VERSION
Document Revision date
Instruction manual 18/02/2022
2 SAFETY INFORMATION
2.1 SCOPE OF APPLICATION
This chapter contains very important
information related to the safety of your
equipment; it is aimed at all staff involved in
any of the stages of the life of this equipment
(transport,
assembly, installation,
commissioning, adjustment, training,
operation, cleaning, maintenance,
troubleshooting, dismantling/removal from
service).
2.2 WARNINGS AND GENERAL
CONSIDERATIONS
✓
The equipment described in this
document has been built in accordance
with the current technological level and
in accordance with the applicable
technical standards in terms of safety.
However, improper use, or incorrect
integration by the end user can generate
risk of injury.
✓
The equipment must only be used in
perfect technical condition, respecting
the
safety regulations and the
instructions provided in this document.
✓
Any breakdown that may affect safety
must be corrected immediately.
✓
Without the proper authorisation of
TECNOSPIRO MACHINE TOOL, S.L. No
modification of equipment should be
made.
✓
The equipment must only be operated
for its intended use. Any other use is
strictly prohibited. Any use other than
that indicated is considered misuse and
is prohibited. The manufacturer assumes
no responsibility for any damage that
may arise from this. This is solely at the
user's own risk.
✓
It is the responsibility of the integrator,
owner and/or end user to determine the
suitability of the product for each use, as
well as its place of installation and the
specific definition of the task to be
carried out with this product within the
limits stated in this manual.
✓
Do not use the equipment in any way
that is not considered in this manual and
pay special attention to the uses
mentioned in section 2.3 EXCLUSIONS,
which must not be carried out.
✓
The operator must only use the
equipment after having received the
instructions for its use.
✓
It is recommended that only one
operator use the equipment at a time,
any other use must be evaluated by the
integrator/end user.
✓
Workpieces (parts to be threaded) must
be properly secured.
✓
The materials used for thread cutting
must be in accordance with the
manufacturer's instructions.
✓
The work area of the equipment and its
surrounding
area must respect
conditions of safety, health and hygiene
at work. It is the integrator/end user's
responsibility to conduct a study to
guarantee safety.