46
Instruction and maintenance manual
ENGLISH
2
TRANSPORTATION
AND HANDLING
MILLERS and GRINDERS can be transported in
wooden crates and mounted onto a pallet to simplify
handling.
2.1 Receipt
All systems are carefully inspected before ship-
ping. Upon receipt, customers should verify that
the packaging and the material inside it has
not been damaged (unless otherwise instructed by
TECNOMAGNETE S.p.A.) in order to ensure that the
system has not been damaged during transport and
that the material supplied complies with order spec-
ifications. Visible transport damages should be im-
mediately reported to TECNOMAGNETE S.p.A. and
the forwarding agent.
ATTENTION
All faults and defects must be reported
within ten
days
from receiving the goods.
2.2 Handling
ATTENTION
All personnel involved in handling loads should
wear protective gloves and shoes.
The customer will always have to verify that all
handling operations are carried out in accord-
ance with applicable safety requirements.
ATTENTION
When lifting or handling the system, always make
sure that the surrounding area is clear and free
from obstacles, and that the recommended safe-
ty distances are maintained, in order to prevent
causing injuries to people and animals or dam-
age to equipment present near the system.
The system is designed to be lifted and handled
with appropriate lifting equipment with charac-
teristics and capacity suitable for the weight to
be handled.
Handling operations must always be performed
very carefully in order to avoid potential impacts
that could damage the system parts and prevent
them from operating correctly.
When using fork lifters, always verify that speed
and inclinations are within recommended values.
Do not leave lifting equipment unattended when
the load is suspended.
ATTENTION
Always verify that the system is disconnected
from energy supplies and that all moving parts
are firmly fixed in place when transporting, han-
dling and storing the system.
ATTENTION
Do not handle lifting systems with electromag-
netic lifters.
ATTENTION
Read all the instructions on the packaging before
opening it.
Always keep the original packaging so that it can
be used to transport the system if needed.
2.3 Transportation
In order to transport the system, it is sometimes nec-
essary to disassemble some of its parts. These parts
will later be reassembled and reconnected during
the installation phase by the service technicians of
TECNOMAGNETE S.p.A. or of the customer under
the supervision of TECNOMAGNETE S.p.A person-
nel.
The system should always be transported within the
following environmental limits: temperature ranging
from –10°C to +55°C, with temperature increase up
to 70°C for a maximum of 24 hours.
If the system requires the use of specific transporta-
tion means (by sea or air), special provisions shall
