EN |
EVO HOT - EVOK HOT
| User and Maintenance Manual
34
5.3 REPLACEMENT OF SLIDING DOORS
In the case of damage and/or replacement of the back sliding doors, proceed as follows:
REMOVAL
1)
Open the front glass (only in the EVO version) until reaching the position of maximum opening.
2)
Disconnect the plug for the lighting unit of the lid.
3)
Unscrew the 4 internal screws that fasten the lid to the display unit (2 screws per side).
4)
Delicately extract the lid. Be careful to not damage the insulating glass on the sides.
5/6) Unscrew the screws located at the sides that fasten the stanchion that supports the upper rail of the
sliding doors.
7)
Unscrew the screws located at the sides that fasten the upper stanchion to the upper rail of the sliding
doors.
7/8) Release the rail of the sliding doors by unscrewing the upper screws that fasten it to the upper stanchion
and remove it.
9/10) Extract the upper rail together with the 2 sliding doors, raising the entire plastic block located at the base.
10/11) Extract the rail from the 2 sliding doors, releasing the single sliding doors.
7
8
1
4
5
6
3
2
