C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 8 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: [email protected]
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Maintenance: Entering the enclosure
Notes
This procedure must only be carried out in a clean, and dry, environment by suitably trained, competent, personnel in
accordance with the applicable code(s) of practice.
Before opening, the unit is to be thoroughly cleaned with clean, fresh, water - refer to the "Precautions: Cleaning"
section of this manual for further details.
Where a security seal 'tag' is fitted to the unit, it must first be ensured that the necessary permissions are in place to
allow entry before proceeding!
Be aware that to prevent the ingress of moisture and debris the lid must not be left off for any longer than is
absolutely necessary!
•
•
•
•
Step 1
Using the appropriate screw
driver, unscrew the two lid
screws (be aware that
tamper-proof 'allen' head
types are usually fitted)
Step 2
Remove the screws and
washers then holding the
unit upright, with the front
facing away, carefully push
the back of the lid forwards
and upwards using your
thumbs - be aware that
forcing them apart using a
screw driver, or similar, may
damage the mating surfaces
and adversely affect the
sealing.
Step 3
Where the enclosure lid is
fitted with an external antenna
connector then the lid is to be
left hanging over the rear edge
of the enclosure base.
Step 4
Carefully wipe the grease off
the gasket to prevent debris
sticking to it and causing
problems with sealing when
the lid is re-fitted.
