TechnoAlpin M20
- 26 -
6.8
S
ETTING THE SHAFT NUMBER
EBENE 2
SCHNEEQUALIT SOLLDRUCK
AUTOMATIK
SOLLPOS.VER
LICHT
SCHNEIBEREIT
SCHWENKEN
SCHACHTNUMMER
l
Level 2 snow quality target pressure automatic snow readiness
shaft number swing target pos. vertical light
In interlinked sites it is important to know which shaft the snow machine is linked to. The M20 snow machine has
the possibility to recognize which shaft it depends on. The assumption for this is a corresponding recognition
module in the ground outlet which will function by means of data cable. Should the recognition module not be
installed, there is the possibility to allocate the shaft number.
Run through level 2 until the shaft number appears on the display (illustration 32):
Bild. 30
Illustration 2
Illus. 32
The pre-set standard value amounts to 255. To alter the set value, press ENTER
and the value begins to
flash.
With the UP
key you can increase the value, with the DOWN
the same is reduced.
To confirm this new value, press the ENTER
key.
Number 255
_ _ _ 0 Shaft number
Summary of Contents for M 20 AT
Page 1: ...2005 M20 AT USER MANUAL...
