TECHNOALPIN M 20 AT, User Manual

Page: 25 / 37

TechnoAlpin M20
- 24 -
6.6 S
ETTING THE HIGH ANGLE
EBENE 2 SCHNEEQUALIT SOLLDRUCK
AUTOMATIK
SOLLPOS. VER LICHT
SCHNEIBEREIT
SCHWENKEN SCHACHTNUMMER
level 2 snow quality target pressure automatic snow readiness
shaft number swing target pos. vertical light
In level 2 it is possible to set up the high angle. The high angle of the M20 snow machine can either be engaged
manually by means of a mechanical crank or can be engaged automatically, provided that an electric motor is
available. In this case the high angle can be set between 0 and 5. The starting point is always the end switch.
(illustration 30) :
Bild. 28
illustration 30
The pre-set standard value is always 1.here. If you want to change this value, press the Enter . The original
value begins to flash.
By pressing the parameter choice key UP you can raise the value, with the DOWN key you can
decrease the value.
To confirm the given value, you press the confirm key ENTER .
You have the 0 value for the vertical position, the cannon remaining at rest. Here you have the possibility using the
turbine high and Turbine low key which are held for manual operation, to reach the
required high position manually.
6.7 S
ETTING THE SWING ANGLE
EBENE 2
SCHNEEQUALIT SOLLDRUCK
AUTOMATIK
SOLLPOS. VER
LICHT
SCHNEIBEREIT
SCHWENKEN SCHACHTNUMMER
level 2 snow quality target pressure automatic snow readiness
shaft number swing target pos. vertical light
In level 2 there is the possibility to set the swing angle.
Setting the swing angle depends on the swing width, where the smallest swing angle corresponds to the value 1
and the largest to value 7.
Run through level 2 until the field for the swing angle appears on the display (illustration 31):
1 Ver
_ _ _ 0 Target position