technoac AP-019.1, Operating Instructions Manual

Page: 45 / 59

DEVELOPMENT, MANUFACTURING AND SUPPLY OF INSTRUMENTATION
45
Colour combinations «U
↔
I».
The possibility in principle to raise the output signal level
«U,В» depending on the combination of the indicators
colours «U
↔
I» (if no other restrictions are in place)
Colour of the glow
«U» «I»
YES
green green
yellow green
green yellow
NO
yellow yellow
red any
any
red
NOTES for «Internal parameters field» and «Output parameters field»
1) Red colour of the glow of any indicator means that «oscillation» is in progress.
2) Parameter or mode the value of which is displayed in the «Digital field» in the «stop» passive
mode is singled out by the flash of the relevant indicator.
11.2.2 «Internal parameters field»
according to the operator choice shows the
following numerical values of the following
parameters in the «Digital field».
1)POWER SUPPLY VOLTAGE in volts « »:
- the lack of the glow – another display
parameter is chosen;
- green colour glow – power supply voltage
in the «stop» mode;
- red colour glow - power supply voltage in the «oscillation» mode.
2) FREQUENCY of the generated signal in kilohertz « f,kHz »:
- the lack of the glow – another display parameter is chosen;
-
green colour glow in the «stop» mode – the set frequency of the output continuous «Co» or
pulse «Pu» signal is indicated in the «Digital field».
11.2.3 «Output parameters field»
(only in «oscillation» mode) at the choice of
operator signifies via red colour the value of
the specific output parameter that is indicated
in the «Digital field»:
- «U,V» - output voltage in volts;
- «I,А» - load current in amperes;
- «P,W» - load power in watts;
- «R,
Ω
» - load resistance in ohms;
- «R,k
Ω
» - load resistance in kilohms.
NOTE
In «antenna» modes «In» and «An» the only value available is «U,V».