DEVELOPMENT, MANUFACTURING AND SUPPLY OF INSTRUMENTATION
11
With factory settings enabled you can perform the cable location with network frequency
50 Hz in without transmitter.
3. Start of work
The screen
saver will
appear on the
screen with the
indication of
the
Firmware
version
,
manufacturer
and device
name
The screensaver
is followed by
voltage and
battery charge
indicator..
Then the receiver will automatically enter
into the mode «Route» in 5 seconds. At the
first switching the factory settings are set by
default. The filter frequency is 50 Hz.
Before start of work, you should install the batteries into the corresponding compartment of
the receiver in the following sequence:
Pull out the ring on the
receiver handle
Battery compartment will
unsnap
Remove the battery
compartment from the
receiver body
Install four new elements into
the battery compartment of the
device, minding polarity
Install the battery compartment
into the body until it snaps.
Note
To switch on the receiver press the button «Power»
Receiver switching on
The description of factory settings can
be found in the menu «Parameters». You
can go back to factory settings by selecting
the parameter «reset settings»
Summary of Contents for AP-019.1
Page 1: ......
