77
Parameters
Pairing status
indicates whether the wireless connection with the device
is established.
Device information
opens a menu similar to the
Version
menu of the
paired device, in addition to displaying the date and time of the last packet
received wirelessly.
Manual mode
On/Off
Specifies the
x2 wireless ID
of the device to which the connection is to be
made
HOP1 ID:
Gives a wireless ID for forwarding signals (see chapter
"Wireless
signal forwarding"
in the installation instructions)
Connect automatically:
If this parameter is set to
Yes
, attempts will be
made at increasingly long intervals to (re-)establish a connection to the
target device.
Pair:
Make a single manual attempt at pairing
With
Connect automatically
(if set to
Yes
), the command to connect may be issued with a time delay
if an especially large amount of data is being sent wirelessly. Manual operation of the
Pair
button
always issues the command
immediately
.
Output variables
Variables received by the wireless device.
Example:
The EHS immersion heater issues the following variables:
• x2 wireless timeout (yes for timeout)
• Current output
• Higher output level
• Lower output level
• Temperature 1 (sensor input 1)
• Temperature 2 (sensor input 2)
• HLSC temperature
• Electronics temperature
• Fault code
Summary of Contents for CAN-EZ3
Page 5: ......
Page 61: ...61 Messages This menu item displays activated messages Example Message 21 is active...
Page 94: ......
Page 95: ......
